thatsnotmyname hat geschrieben:Adam hat geschrieben:An jede einigermaßen ordentliche moderne Kamera lässt sich doch ein externes Intervalometer anschließen.
Die NEX-5R hat leider keinen Anschluss für einen externen Auslöser, das habe ich schon geprüft.
Ich bin nach auf der Suche nach einter Alternative auf das hier gestoßen, das klingt ganz interessant, auch wenn es etwas laienahaft aussieht:
http://kleinanzeigen.ebay.de/anzeigen/s ... 9-245-9449
Hat sonst noch jemand Ideen?
ich HABE noch so ein ding ! funzte ganz gut ... ich such mal eben die anleitung .. und mach n foto .. ich brauchs nich mehr, weil ich nun die A7 hab ...
/edit : hatte es an der nex und aus ebay .... is ne platine + akkufach ... mehr nich ....
/edit 2 :
anleitung:
Two LED indicator: left LED for IR Emitting, right LED is status indicator.
Choose from page 1~page 9 (Press button B2 to change page)
1. Single Shutter Release (B1 for send signal)
2. 2S Delay Shutter Release (B1 for send signal)
3. Bulb Shutter Release (Nex5 to be set for Manual Focus (MF)) (B1 for send signal & time count begins. Then press B2 to stop signal, and time count ends)
4. Time Lapse
(Nex5 to be set for Manual Focus (MF))
(Note: pls switch off Nex5 Noise Reduction)
(Note: pls switch off auto review photo )
B1 sends signal. Then press B2 to stop. Setting resumes initial.
(Setting: Long-press B1 for over 2 seconds, display shows 'Setting', press B2 to increase value, press B1 for switch screen and run)
Lapse (1~60) increases by 1 per press, Shot (10~600) increases by 10 per press. At Page 9 we can set to return lowest initial value.
5. Time Expro
(Nex5 to be set at Manual Focus MF)
(Nex5 noise reduction to be switched off)
Mode to be set as "M", release shutter to be set as "B"
B1 sends signal. Then press B2 to stop. Setting resumes initial.
(Setting: Long-press B1 for over 2 seconds, display shows 'Setting', press B2 to increase value, press B1 for switch screen and run)
Lapse (1~60) increases by 1 per press, Shot (10~600) increases by 10 per press. At Page 9 we can set to return lowest initial value.
6. Battery
Display battery /power supply voltage status
7. Backlight
No backlight for save of power
8. LED Signal
Switch on/off the two LEDs onboard
9. Clear Setting
Time Lapse, Time Expro resumes initial setting
steht drauf : für nex 5, 5n, 7 ...
aber ich glaube, mehrere tage, das funzt nicht.... *grübel* ....