Hallo habe seit Gestern die Fehlermeldung E-17014.
Wer kennt diesen Fehler und was kann ich dagegen tun?
Begleiterscheinung.
Kann nicht mehr Fokussieren-Display fehlt Hintergrungbeleuchtung-Zoom geht nicht mehr.
Wenn ich dann Akku rausnehme funktioniert bis auf Displayhintergrundbeleuchtung alles für ca. 1Minute alles wieder.
Dann das gleiche Problem.
Würde mich über Hilfe sehr freuen,zumal ich in 2 Wochen einen Auftrag durchführen muss.
Beste Grüße
Check the connection with the lens unit. If there is
no defect, replace the lens unit.
Zu beachten:
If multiple errors occur simultaneously
The highest-priority error is displayed.
When an error with a higher priority is cleared, the one with the next priority is displayed.
Vielen Dank für die schnelle Antwort.
Das bedeutet Reparatur!
Oder kann ich den Kontakt von Lenseinheit selbst prüfen?
Ist doch festverbaut oder täusche ich mich?
Dürfte doch mit der Lensgeschichte nicht zusammen hängen oder?
Sehe ich ähnlich.....
deshalb:
If multiple errors occur simultaneously The highest-priority error is displayed.
When an error with a higher priority is cleared, the one with the next priority is displayed.
Du kannst aber mal eine Selbstdiagnose der Kamera ausführen, den Code kenne ich allerdings nur für meine EX1R:
To display the SERVICE menu, the following operations are needed.
1. Close the LCD monitor.
2. Set the LCD B.LIGHT switch on the upper operation panel to the “OFF” position.
3. Set the GAIN switch on the side operation panel to the “H” position.
4. Press the CANCEL button, the MENU button, and the Jog dial at the same time.
5. When the LCD monitor is opened, the SERVICE menu is displayed.
. Pressing the MENU button again closes the SERVICE menu display.
. Once the SERVICE menu has been displayed, simply pressing the MENU button displays the SERVICE
menu instead of the normal SETUP menu unless the power is turned off.
Diagnostic Function
Self Diag of INFORMATION menu enables the user to execute self-diagnosis of the equipment. When
Self Diag is run, the result of self-diagnosis appears regardless of whether the result is good or bad.
The self-diagnosis can be executed only under the following conditions. When executing the self-diagnosis,
change to the following conditions with the SHUTTER switch and the SETUP menu.
. SHUTTER switch: Off ← lower front of the unit
. EX Slow Shutter: Off ← CAMERA menu
. Country: NTSC Area ← OTHERS menu
. Video Format: HQ1080/60i ← OTHERS menu
------------------------------------------------
1. Self-diagnostic items
The following two types of self-diagnosis are provided.
In addition, since the system cannot be returned to normal operations after the self-diagnosis, the
power must be turned off and on again.
. Type1: Simple self-diagnosis
Use to execute a simple version of the self-diagnosis. This fi nishes in a short time.
. Type2: Complete self-diagnosis
This executes all items included in the Self Diag. Since complete self-diagnosis involves a memory
test and a complicated device test, this requires time to be completed.
Self-diagnostic item list:
Item No. Self-diagnostic item Description
Item1 Image processor block Diagnosis of lens, CMOS block, and camera block
Item2 Display block Diagnosis of video signal system (LCD and base band signal
processing)
Item3 Media block Diagnosis of media recording and playback (encoder, decoder,
memory card, i.LINK and USB interface)
Item4 Audio block Diagnosis of audio input and output
Item5 System controller block Diagnosis of system controller system
Item6 Power block Diagnosis of power supply system
Item7 I/F between image processor Diagnosis of the signal line from camera signal processor IC to
and display block base band processing IC
Item8 Video I/F while recording between Diagnosis of the video signal line (recording direction) from base
display and media block band processing IC via encoder IC to AVIT signal processing IC
Item9 Video I/F while playing back Diagnosis of the video signal line (playback direction) from AVIT
between display and media block signal processing IC via decoder IC to base band processing IC
Item10 Audio I/F while recording between Diagnosis of the audio signal line (recording direction) from base
display and media block band processing IC to AVIT signal processing IC
Item11 Audio I/F while playing back Diagnosis of the audio signal line (playback direction) from AVIT
between display and media block signal processing IC to base band processing IC
Item12 Do not execute this item.
Item13 Do not execute this item.
Rechtliche Notiz: Wir übernehmen keine Verantwortung für den Inhalt der Beiträge
und behalten uns das Recht vor, Beiträge mit rechtswidrigem oder anstößigem Inhalt zu löschen.
